ZE3127S Electrical Training Equipment Vocational
Training Equipment Educational Equipment Teaching Equipment
1.Data acquisition module 1 piece
(1) the "L1 and N" on the module hanger is provided by power output
terminals on the power box.
(2) "Torque input, Speed input" air plug seat, which is connected
to the Torque sensor using a special aviation plug line (blue box);
"USB out" USES a dedicated cable to connect to a computer for
2.Semi-controlled bridge thyristor module 1 piece
Semi-controlled bridge thyristor module hanging box can complete
the half-control bridge rectifier experiment.
3.Three-phase rectifier module 1 piece
(1) "L1, L2 and L3" on the module hanger are provided by power
output terminals of the three-phase AC380V power supply box on the
(2) the dc voltage of "+, -" output DC550V on the module hanger.
4.Siemens inverter module 1 piece
5.DC semiconductor thyristor drive module
(1) product features:
PWM pulse width modulation.
It adopts SMT technology and small volume.
It is suitable for rare earth, permanent magnet type, he excited
type and dc torque motor.
Double closed loop P I regulation (voltage, current)
It has good following and quick response.
The speed regulation ratio is wider and the mechanical properties
It is limited to current protection and short circuit protection.
The starting torque is large at low speed.
It enables the control function.
Soft start setting function.
Standard signal input or 2W/10K potentiometer control drive speed
(2). Technical parameters:
Input voltage AC: 220V (other voltage can be customized according
to customer requirements)
Output voltage DC: 0-220v (set)
Output voltage accuracy: less than 0.1.
Rated output current: 4A.
Speed regulation ratio: 100:1.
Standard signal: 0-5v, 0-10v, 4-20ma.
Soft start time: 0.2s-10s.
- environmental temperature: - 10 ℃ ~ + 60 ℃
Environmental humidity: the relative humidity is no more than 65.
Instantaneous short circuit protection: 50us.
Insulation pressure: 1500V AC.
- insulation resistance: > 500 m Ω
Leakage current: less than 0.09mA.
(3) product performance:
1. With a hard mechanical characteristic, the static error rate is
2. With wide speed range, (0 - MAX speed MAX SPD set value).
3. It has a fast dynamic response process.
4. Automatic smooth transition process with addition and
5. Can automatically limit the overload current to the set value
6. High reliability, compact structure, high cost performance.
6.Single-quadrant DC drive module 1 piece
(1) The DC brushless motor and rotary encoder are fixed on the base
board and connected with the coupling, and the encoder terminals
are connected to the speed table by using the aviation plug test
(2) Connect the DC brushless motor to the drive according to the
following figure. EN and DIR use the 2mm safety cable, connected to
GND1 terminal by switch (switch potentiometer hang box
ZE3115S-module -1). Can realize start-stop and forward and reverse
7.Server driver module 1 piece
(1) connect the servo motor in the ZE3125S single phase ac motor,
and connect "U, V, W, PE" to the "U, V, W, PE" terminal of the
servo drive using the 4MM SAFETY test line;
(2) use the servo motor special line to connect to the "CN3"
(3) use the 4mm safety electrical cable of L1, L2, L3 and PE on the
power box to the servo drive L1, L2, L3 and PE terminals for test
8. Electromagnetic brake 1 piece
9. Load calibration module 1 piece